Veeam backup Agent for Linux update to BETA2 on CentOS 7

 

Now I want to update it with newer version “beta2” which was released recently. First of all download BETA2 files for your Linux distribution. In my case RPM files for RedHat/Centos 7 from Veeam site.

First of all you need to uninstall “beta1” to be able to install “beta2” properly.

Continue reading “Veeam backup Agent for Linux update to BETA2 on CentOS 7”

new NUC in my home lab

 

Home LAB starts to grow. More and more test lab VM’s, nested ESXi hosts etc. So  I was looking for another node. Dont want to spent a fortune so the price was the key. I had also other minimum requirements as 32GB of RAM and power consumption. After few weeks of searching I decide to buy a Intel NUC.

Components added to my #HOMELAB:

  • Intel 6th Generation NUC NUC6i3SYH
  • 2x Kingston 16GB DDR4 2133MHz SODIMM
  • USB3 TP-LINK  UE300 gigabit NIC
  • 8GB San Disk Cruzer Fit
  • HDMI to VGA adapter

 

Disclaimer: The Intel NUC is not on VMware’s official Hardware Compatibility List (HCL)

Veeam backup Agent for Linux (beta) CentOS 7

today just received an email from Veaam with link and code. So I can download the beta agent for linux.  In my case I will use CentOS 7  linux distribution 64bit.

Installation is easy, with some tricky part. As on installation page here is step-by-step  info about how to install the Veeam Linux agent. But I am missing step-by-step info about how to install prerequisites. So you can read it here for CentOS 7 Linux.

First of all update your server. Once done,  reboot the server if during your update was installed new kernel.

Continue reading “Veeam backup Agent for Linux (beta) CentOS 7”

2nd NIC for my NUC

Intel NUC is the best piece of HW for HOME mini-LAB. But once you start grow you need more network bandwith. And one pNIC is not enough. After few sec of googling I find great page DevTTY. Where is a lot of information about “supported” USB NIC for your Intel NUC. I choose TP-LINK UE300 because I had a couple of TP-LINK (3210, 5426) switches and they are doing great job.

So I ordered TP-LINK UE300 USB 3.0 network card. Once it was delivered to me, I connected it to the NUC. Then download the driver from DevTTY and upload it to one of my datastore.  No maintenance, reboot is needed. The only thing you need to do is to change the “Host Image Profile Acceptance Level”  to  “Community supported”.

Host Image Profile Acceptance Level-Community

Then just log in to the ESXi console and install VIB file with command:

Continue reading “2nd NIC for my NUC”